Battery Run Down - Compartment Leak

Warranty & RMA
1

I put Lithium batteries in my four units hoping to lengthen the time between replacement, but I had one sensor/set go to 0% or not reading since No25. The other three are still at 100%. So, I thought maybe a couple of bad batteries is not out of the question. Well, I pulled that one up and it’s not the batteries fault. Compartment water leak. I thought I had taken such care and cleaned and sealed carefully. I understand how important that O-ring is.

Any suggestions on how to clean the compartment to make sure I get all the dirt and rust out?

Vinegar/Baking powder is my normal go to solution.

0
01567×1175 126 KB

2
2881×1175 99.7 KB

IMG_7099
IMG_70991920×2560 614 KB

2

Hi @ebelew ,

Thank you for sharing these details. We’d like to take a closer look at your unit to better understand what’s happening and get this resolved for you.

I am reaching out to you via email right now with RMA instructions and next steps. Please keep an eye on your inbox.

Thanks for your patience,

Stanley
Marketing PM
Team GeoDrops

3

I got the information. Thank You.

I’ll get it shipped out.

Eddy

1 Like
4

Thanks @ebelew .

Stanley
Marketing PM
Team GeoDrops

5

Hi @ebelew ,

I think I got your responses regarding your RMA replacements on someone else’s RMA thread. Can I go ahead and close this thread too?

Stanley
marketing PM
Team GeoDrops

6

Yes. Please close this.

1 Like